Slide 1 Caption

Dapiensociis temper donec auctortortis cumsan et curabitur condis lorem loborttis leo. Ipsumcommodo libero nunc at in velis tincidunt pellentum tincidunt vel lorem pellus sed mauris enim.

Slide 2 Caption

Dapiensociis temper donec auctortortis cumsan et curabitur condis lorem loborttis leo. Ipsumcommodo libero nunc at in velis tincidunt pellentum tincidunt vel lorem pellus sed mauris enim.

Slide 3 Caption

Dapiensociis temper donec auctortortis cumsan et curabitur condis lorem loborttis leo. Ipsumcommodo libero nunc at in velis tincidunt pellentum tincidunt vel lorem pellus sed mauris enim.

Slide 4 Caption

Dapiensociis temper donec auctortortis cumsan et curabitur condis lorem loborttis leo. Ipsumcommodo libero nunc at in velis tincidunt pellentum tincidunt vel lorem pellus sed mauris enim.

Slide 5 Caption

Dapiensociis temper donec auctortortis cumsan et curabitur condis lorem loborttis leo. Ipsumcommodo libero nunc at in velis tincidunt pellentum tincidunt vel lorem pellus sed mauris enim.


Milling Cutters with Unicart Holding System

Spectra has designed and developed special side and face milling cutters using our pending patented 'UNICART HOLDING SYSTEM' which can be used at up to double the feed and speed than any other conventional milling cutters and still achieve very good finish. This is achieved by many design factors incorporated as follows

  1. Very simple design, very sturdy, Small in size and weight, Easy interchange ability, maintaince and adjustment.
  2. Through coolant provision.
  3. Can be manufactured to suit any type of Inserts (ISO &Non-ISO),PCD, CBN, Brazed Carbide and screw clamped carbide inserts.
  4. Any kind of geometry can be provided to machine all kinds of materials.
  5. Cartridge can be set to vary close run out (1-2 microns) on machine before setting on a pre setter. Spectra milling cutters can be supplied with any kind of taper holding system as per request.
  6. Cartridge heights can be increased or decreased at will to achieve uniform height. Spectra Face Milling Cutters range starts from Dia 32 to Dia 200 mm and Reamers ranges starts from Dia 8 mm onwards.